3850712.01 Dinosaur Electronics Dometic PC Board  Dinosaur Electronics 3850712.01 Replacement

Use 3850712.01 Dinosaur Electronics Dometic PC Board ONLY TO REPLACE PREVIOUSLY PROPERLY INSTALLED DOMETIC® 3850712-01 BOARDS.

Features: 

Built in Ignitor.

2-way or 3-way operation.

Variable Temperature adjustment for those FIXED TEMP refrigerators.

The CHECK light comes on after each ignition try fails to sense a flame.

Repeats the 3 try ignition cycle at 30 minute intervals if no flame is sensed.

* In 3-way models, the DC element will drop out and the DC mode light will flash, if the voltage level falls too low for more than 10 seconds.

Use ONLY as a REPLACEMENT for PREVIOUSLY PROPERLY INSTALLED Dometic®
The characteristics of the Dinosaur Electronics #3850712.01 replacement are as follows:
1) It automatically determines whether it can operate as a “2 way” or “3 way” based on previously
installed kits, and the appropriate eyebrow.
2) It has a “temperature adjustment” control to allow the installer or end user to set the operating
temperature range of the “Automatic” temperature refrigerator to the customer’s
satisfaction. The control is preset to “3” when shipped from the factory.
3) It functions properly with all AES, AMES, 2 way, 3 way, adjustable, or fixed temperature
eyebrows.
4) In GAS mode with NO FLAME SENSE, the timing is as follows:

A) 1st “45” sec ignition try – then – turn ON check light.
B) “2” min wait – then – turn OFF check light.
C) 2nd “45” sec ignition try – then – turn ON check light.
D) “2” min wait – then – turn OFF check light.
E) 3rd “45” sec ignition try – then – turn ON check light.
F) “30” min wait with the check light ON.
G) Turn the check light OFF and repeat steps “A – E”.

The check light will be reset if:
a) The refrigerator is turned OFF and back ON.
b) A different mode is tried and then returned to GAS mode.
5) In GAS mode – when a flame is sensed on any try, the entire “3 try” sequence of “A – G” will
be reset. samples details  email  more.

 Three year warranty